The Subnet mask (Figure 1: ) defines a network ID and host ID within the IP Address. AutoIP + DHCP - use an IP address that configures itself after VSpy goes online with hardware.Manually assigned - use the IP address entered.Inherit from OS - use the IP address of the operating system VSpy is currently running in.A typical address to use is in the range from 192.168.000.000 toġ92.168.255.255 which is reserved for private networks. Vehicle Spy displays the address as a series of four bytes in decimal format. Needed to route ethernet traffic correctly. ![]() The IP Address (Internet Protocol) (Figure 1: ) is a dynamic address associated with a virtual node which is assigned as Manually assigned - use the MAC address entered.Inherit from device - use the MAC address of ICS hardware that is online with VSpy.The first three bytes of the MAC Address are 00:FC:70 for ICS hardware. Vehicle Spy displays the address as a series of six bytes in hexadecimal format. The MAC Address (Media Access Control) (Figure 1: ) is a static address associated with a physical ethernet device. TCP requires the Tools > Options > Spy Networks tab setting "Use PC Ethernet interface" = ON. TCP also has a predefined column set on Messages view to quickly organize the data from the TCP has a virtual network in Vehicle Spy to expose data hidden within the raw ethernet traffic found on the physical networks like "Ethernet"Īnd "OP (BR) ETH01". Maps virtual IP addresses to physical MAC addresses. Link-local IP address configuration per RFC 3927.ĭynamic IP address distribution per RFC 2132. Supports data flow from one node to nodes in a specific group. ![]() Supports data flow from one node to all nodes. Table 1: Ethernet Protocols Supported in VSpy's TCP/IPĬontrols addressing to ensure data gets to the correct node. TCP/IP view is opened from theĮthernet communication involves many protocols and TCP/IP view supports the following: A maximum of 128 connections are allowed. Is required for Diagnostics over IP (DoIP). Vehicle Spy's TCP/IP view shows the current status of its TCP/IP connections for a selected ethernet network and allows editing of some parameters.
0 Comments
Leave a Reply. |